Home / Products / Tubular Sleeves & End Caps
Heat shrinkable end sealing materials for insulated steel pipes, helping protect exposed insulation ends during handling, storage and use.
DN65–DN800 • Standard width: 160 mm • Straight and moulded types
Request a Product Quote Browse All ProductsThe end cap seals between the steel pipe and the outer insulation jacket. Straight and moulded configurations accommodate different insulated pipe end requirements.
End sealing of insulated pipelines and protection of exposed foam insulation. Confirm steel pipe diameter, jacket diameter and insulation thickness for correct sizing.
Pipe diameter: DN65–DN800, customizable. Standard width: 160 mm; custom width: 50–700 mm. Standard thickness: 2.0–2.5 mm; custom thickness: 1.5–3.0 mm.
Carton or woven-bag packaging is available. Provide pipe and jacket dimensions, insulation thickness and quantity for selection.
Request the technical data sheet and confirm the sealing design and acceptance requirements for the selected end-cap configuration.
Store at 5–30°C, below 75% relative humidity, away from heat and flames. The stated storage period is 12 months under the recommended conditions. Installation should follow the supplied technical instructions and the project-approved surface preparation, primer and heating procedure.
Send the pipe outside diameter, operating conditions, existing coating, required dimensions, quantity, delivery destination and project standard. Our team can then confirm the appropriate system and provide a product-specific quotation.